APPENDIX B. MANEUVERING POSITION (Con't).
Proceed slowly and with caution to prevent equipment damage.
If operating a dolly half equipped with side lift kit, extension of lift and positioning
cylinders should stop when top beam vertical tubes have extended approximately 49
in. (124 cm) and positioning cylinder limit lines are just visible.
Pull down on two lift cylinder levers (56) to extend lift cylinders (73) and positioning
cylinders (2). Stop when near (left side) top beam vertical tube (58) reaches within in.
(13 mm) of hydraulic control valve (74) and fittings (90).
Continue to pull down on two lift cylinder levers (56), allowing near (left side) lift
cylinder (73) to lead far (right side) lift cylinder. Maintain clearance of 1/8 in. (13 mm).
If operating a dolly half equipped with side lift kit, return positioning cylinders lever
(71) to NEUTRAL position.
Continue to pull down on two lift cylinder levers (56) until bottom beam (3) is raised off
the ground and axle (42) and pivoting tray (65) are parallel to the ground. Dolly half is
now in maneuvering position.
While in maneuvering position, DO NOT operate positioning cylinders lever. Failure
to follow this warning may cause bottom beam to lower to the ground, causing
serious injury to personnel.
Return positioning cylinders lever (71) to NEUTRAL position, as required.