MWO 9 -2330-390-35-1
9. SPECIAL TOOLS; TOOL KITS; JIGS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND FIXTURES REQUIRED.
a. Hand tools and tool kits necessary to apply MWO are listed:
Tool Kit, General Mechanic's
Kit, Redundant Power
Wrench, Twist Lock
8D00136 (Provided w/ Dolly)
Drill Set, Twist
Drill, Electric, Portable
Welder, Short Arc Mig
b. Tools necessary to apply MWO are contained in the following shop set:
Automo tive Maintenance
Use extreme caution when handling heavy parts. Lifting device is required
when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45
Kg) for a two person lift, and over 150 lbs (68 kg) for a three or more person
lift. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may cause serious injury or death to personnel
Hydraulic lines should be tagged before removal.
Positioning cylinder ports should be plugged with masking tape or other
suitable means as lines are disconnected or fittings are removed.
A suitable container should be used to catch any draining hydraulic fluid.
Ensure tha t all spills are properly cleaned.
a. DOLLY PREPARATION
Preparation procedures are the same for front and rear dollies.
1. Uncouple Dolly set from Tow vehicle
2. From the transport or travel mode (Figure 2) perform operations needed to