MWO 9 -2330-390-35-1
person reporting the MWO data, will acquire the remaining elements (3 &
5), and input all nine into MMIS.
Material Change Number (MCN)
Unit Identification Code (UIC) @ Battalion Level
NSN of End Item
USA Registration Number
Date of Application
Hours required for Application.
For off- line reporting, the 3.5- inch disk shall be mailed to the following
Warren, MI 48397-5000
b. Marking Equipment.
(1) After the Positioning Tube Reinforcement Kit is installed, mark MWO
under 9-2330-390-35-1 in the MWO Applied block and Date Applied in
Date Block on MWO instruction plate P/N 10930014 (91).
(2) To install the MWO instruction plate, locate and drill a 0.082-0.086 inch
diameter hole on the front upper left (hydraulic valve side) vertical tube
above the instruction plate (see figure 11). Use #4-3/16 drive screws to
15. MATERIAL CHANGE (MC) NUMBER.
a. The Material Change (MC) Number for this MWO is 1-02-08-0001
16. MODIFICATION IDENTIFI CATION.
a. When installed correctly, the Positioning Tube Reinforcement Kit will appear as
b. After the Positioning Tube Reinforcement Kit is installed, the positioning tube
reinforcement should be inspected for secure mounting. Any faults detected, or
discrepancies noted, will be corrected before the dolly is returned to normal