d. Drilling Spare Tire Mounting Bracket (see
C in spare tire carrier.
Figure 4-2. Drilling Engine Compartment.
Figure 4-4. Spare Tire Mounting Bracket.
(1) Drill two holes A in the rear of windshield
frame. Holes are to be drilled 7/16 inch (11 mm) from
the top edge and 3 inches (7.6 cm) from each side
Drill holes B from underneath whenever
(2) Drill a hole B in each side edge of
windshield frame. Holes are to be drilled 1 1/2 inches
(3. 8 cm) from the top edge and 1/2 inch (13 mm) from
the rear edge.
(3) Drill three holes C in the bottom edge of
windshield frame. All holes are drilled 3/4 inch (19 mm)
from the front edge of the windshield. One :hole is
drilled 1 1/2 inches (3.8 cm) toward the center from the
Figure 4-3, Drilling Crew Compartment