TM 9--2520--215--34
0039 00--27
STEER CLUTCH HOUSING ASSEMBLY REPAIR CONTINUED
0039 00
ASSEMBLY Continued
39. Install steer tie--shaft drive gear (8), flat--side down, onto steer clutch hub and center it. Use two 7/16--20 bolts to
align gear holes with those in steer clutch hub.
40. Remove 7/16--20 bolts used as guides. Install tie shaft drive gear ball bearing (9), snap ring end up. Tap bearing
assembly down until seated against spacer.
9
8
NOTE
Snap ring has L--shape cross section. Flat side of ring must be installed up. When compressor
assembly is released, bearing is pushed up by Belleville and locks snap ring in groove.
41. Install compressor assembly. Compress steer tie shaft drive gear (8). Install new snap ring (10).
10
8