TB 9-2350-368-25
g. Battery Box
Bill Of Materials
Item
Nomenclature
Part Number
NSN
Qty
2" by 2" by 1/4" Steel Angle
1
48 inches (121.9 cm)
2
2" by 3" by 1/4" Steel Angle
2
11-1/4 inches (28.6 cm)
2
2" by 2" by 1/4" Steel Angle
3
15 inches (38.1 cm)
4
1. Cut two steel angles (1) final length of 48 inches with 45 angle on each end. See Figure 2-11.
2. Cut two steel angles (2) final length of 11-1/4 inches with 45 angle on each end. See Figure 2-11.
3. Weld two steel angles (1) and two steel angles (2) together. See Figure 2-11.
4. On the 3-inch side, scribe a line 7 inches down from the top of steel angle (3) and another 6-7/8 inches
from the 7-inch line.
5. Scribe two lines 5/8 inch on the 3-inch side from each side of steel angle (3).
6. Drill four 9/32-inch holes where the scribed lines intersect, to mount the STE/ICE shunt. See Figure 2-
7. Scribe a line 9-1/4 inches down from the top of steel angle (3) and another 2-53/64 inches down from 9-1/4
inch line. See Figure 2-11.
8. Scribe a line 7/8 inch from edge of steel angle (3). See Figure 2-11.
9. Drill two 7/16-inch holes where the scribed lines intersect, to mount bus bar. See Figure 2-11.
10. Weld four steel angles (3) 12 inches from ends of two steel angles (1) on center tubing. See Figure 2-11.
11. Position and weld four steel angles (3) on the rear cross horizontal tubing, and the other on rear
perpendicular tubing. See Figure 2-11.
2-16
