TM 9-2510-247-13&P
0063 00
REMOVAL - Continued
1.
Remove hydraulic hose from elbow (1).
2.
Remove hydraulic hose from tee fitting (2) and upper safety valve (12).
3.
Remove hydraulic hoses from elbows (3).
4.
Remove hydraulic hose (4) from cylinder (5).
5.
Remove tee fitting (2) from straight adapter (6).
6.
Remove straight adapter (6) from cylinder (7).
7.
Remove elbows (3) from cylinders (5 and 7).
8.
Loosen two screws (8) and remove retaining pin (9).
9.
Using a suitable lifting device and two personnel, lower cylinder assembly (5 or 7) to mast. It
may be necessary to release some pressure from the cylinder to allow the cylinder to collapse
enough to clear the mounts.
10.
Loosen two screws (10) and remove retaining pin (11).
11. Remove cylinder assembly.
12. Repeat steps 8 through 11 for remaining main frame to mast cylinder assembly.
INSTALLATION
1.
Using a suitable lifting device and two personnel, position bottom of cylinder assembly in bracket
and secure with retaining pin (11).
2.
Tighten two screws (10).
3.
Raise cylinder assembly and install retaining pin (9).
4.
Tighten two screws (8).
5.
Repeat steps 1 through 4 for remaining main frame to mast cylinder assembly.
NOTE
Use sealing compound on all threads before installing fittings.
All hydraulic hoses must not be recapped and/or unplugged untin connecting
to prevent contamination of hydraulic system.
Replace plastic ties as needed.
0063 00-2
