TM 9--2520--215--34
0081 00--2
OIL PRESSURE READINGS AND FUNCTIONAL TEST (TRANSMISSION
INSTALLED IN VEHICLE) – CONTINUED
0081 00
OIL PRESSURE READINGS – Continued
1. Remove six screws (1) and six lockwashers (2). Discard lockwashers.
2. Remove saddle cap assembly (3) and retainer (4).
3. Disengage coupling (5) by sliding toward output reduction gear assembly.
4. Reinstall cap assembly (3) with six screws (1) and six new lockwashers (2). Torque screws (1) to 67--80 lb-- ft.
Do not install retainer (4).
1
2
3
4
5
5. Check transmission oil level (LO 9--2350--256--12 or TM 9--2350--292--10). Add or drain oil as required to
establish correct oil level.
6. With shift selector control in neutral position start engine and allow transmission to run until normal operating
temperature (approximately 200 degrees F on the XT--1410--4 or 160--260 degrees F for the XT--1410--5A) is
reached.
CAUTION
Do not exceed 1020 rpm during reverse range operation.
7. During warm--up, input speed should be approximately 980 to 1020 rpm. Shift through all ranges several times to
ensure that hydraulic system is completely charged. Reduce input speed while making shifts from forward to
reverse range or from reverse to forward range.
