MWO 9-2330-390-25-1
TACOM-Warren
ATTN: AMSTA -LC-CIPWM
Warren, MI 48397-5000
b. Marking Equipment.
(1) After the Positioning Tube Reinforcement Kit is installed, mark MWO
under 9-2330-390-25-1 in the MWO Applied block and Date Applied in
Date Block on MWO instruction plate P/N 10930014 (91).
(2) To install the MWO instruction plate, locate a single 0.107 inch diameter
hole (#37 - drill size) on the front upper left (hydraulic valve side) vertical
tube above the instruction plate (see figure 9). Use #4-3/16 drive screws to
attach.
15. MATERIAL CHANGE (MC) NUMBER.
a. The Material Change (MC) Number for this MWO is 1-05-08-0001
16. MODIFICATION IDENTIFICATION.
a. When installed correctly, the Positioning Tube Reinforcement Kit will appear as
shown in figure 7.
b. After the Positioning Tube Reinforcement Kit is installed, the positioning tube
reinforcement should be inspected for secure mounting. Any faults detected, or
discrepancies noted, will be corrected before the dolly is returned to normal
service.
9
