MWO 9-2330-392-20-2
WARNING
When installing breakaway lever spring onto breakaway lever and
actuator housing you must hold the spring in place until master cylinder
is installed. If the spring is not physically held in place as defined, it
can fall out of the actuator housing, resulting in no surge brake
protection for the trailer.
11. Reinstall breakaway lever spring (10) (see Figure 17) between master cylinder and
breakaway lever. Reinstall master cylinder, torque cap screws to 30 3 ftlb (see Figure
12. Install landing leg pivot, use one new lock washer with existing screw and two new
locking hex nuts with existing flat washers and existing bolts. Torque screw to 210 20
ftlb and locking hex nuts to 150 10 ftlb (see Figure 4).
10
Figure 17
13. Install leveling jack and secure with quick-release pin (see Figure 3).
13
