TB 9-2300-422-20
a. The design of the steering column on the M880 vehicle will not permit the use of a standard clamp as a chain
attachment. The following procedure should be utilized.
b. Attach fixed end of chain with a 3/8 in. (9.5 mm) machinescrew, lockwasher, and nut into manufacturer's hole that
is located in the rear of seat riserplate on the operator's side of vehicle. Fasten the chain on the inboard side of riser (Fig.
3). The nut is to be located on the outboard side of riser and, after securing, the screw should be staked to prevent
removal.
Figure 3. Chain in the Stowed Position.
2-4. Mounting Hardware, M880 Installation only.
NOMENCLATURE
PART NUMBER
NSN
Screw
MS35308-364
Washer
MS35338-141
Nut
MS51968-8
5310-00-732-0559
5
