TM 5-3655-210-12
Section XVIII. SPRINGS
4-82.
Torque Arms
are installed, take care to maintain axle alinement
dimensions presented on figure 4-81.
c. Adjustment. Refer to figure 4-81 and adjust
a. Removal. Refer to figure 4-81 and remove the
axle spacing as indicated to within 1/16 in. (.1588 cm)
torque arms.
of values given.
b. Installation. Refer to figure 4-81 and install the
torque arms. If replacement adjustable arms
Figure 4-81. Torque arm adjustment and removal.
Section XIX. BODY
4-83. Description
b. Installation. Position the reflector on the trailer
and secure with the two machine screws.
The pressure vessel power compartment and
storage compartment are completely inclosed by
4-85. Power Compartment Door
aluminum panels. Two access doors are provided in
both the power and storage compartments and the rear
a. Door Removal. Remove the rivets securing the
pressure vessel. Access plates are provided to the gas
door to the housing and lift off the door.
tank, over each of the four lifting eyes, the front
b. Disassembly.
pressure vessel, and one at the front of the trailer for the
(1) Remove the two cotter pins (20, fig. 4-82)
wiring connections. Reflectors are provided at each
and washers (19) securing the two rods (1 and 14) to the
corner of the trailer and at the front and rear of the
lock (15).
trailer fenders.
(2) Lift the rods from the lock and remove
them through the holes in the door brackets.
4-84. Reflectors
(3) Lift the spring (18) from the lock.
(4) Remove the four machine screws (26) and
a. Removal. Remove the two machine screws
lockwashers (27) securing the lock to the door (4), and
securing the reflector to the trailer, and remove the
remove the lock.
reflector.
4-90
