TM 5-3655-210-12
TS 024603
1 208 v, ac power receptacle
2 Vapor equalizing line
6 Blackout stop and taillight
3. Liquid fill line(pump by-pass)
7. Pintle hook
4. 24 v., dc receptacle
8 Capscrew
5. Liquid fill line
9 Stop and taillight, service
Figure 4-76. Power receptacles, installed view.
(8) Remove the four nuts (4) and lockwashers
(1) Remove the nut (2, fig. 4-78) or (2, fig. 4-
(3) securing the mounting bracket to the frame, and
79), lockwasher and capscrew (4), securing the diagonal
remove the bracket.
brace (3) to the mounting bracket (1).
(2) Remove the nut, lockwasher, and
WARNING
capscrew (16, fig. 4-80) securing the brace (17) to the
Dry cleaning solvent, P-D-680 or P-S-661,
landing jack (21), and slide the brace out through the
used to clean parts is potentially dangerous
power compartment.
to personnel and property. Use in a well-
(3) Remove the four screws (20), securing the
plate (18) and gasket(19) to the housing, and remove
ventilated area as the fumes are dangerous if
the plate and gasket.
inhaled. Avoid repeated and prolonged skin
(4) Remove the nuts, lockwashers, and
contact. Do not use near open flame or
capscrews, securing the cross brace (11) to the landing
excessive heat. Flash point of solvent is
jacks (21), and remove the brace.
100F.-138F. (38C.-59C.).
(5) Remove the nut (14), machine bolt (12),
and the two washers (15), securing the foot (13) to the
b. Cleaning, Inspection and Repair. Wash all parts
landing jack, and remove the foot and slide the spacer
with a cleaning solvent. Inspect the threads for damage,
from the jack.
and replace damaged nuts. and capscrews. Inspect for
(6) Remove the nuts, lockwashers, and
cracks, breaks, bends and distortion. Repair minor
capscrews, securing the crank handle (9) and bracket
breaks by welding, and straighten any bends. Replace
(23) to the jack and remove the handle.
all badly damaged parts.
(7) Remove the nine nuts (5), lockwashers (6),
c. Reassembly and Installation.
Reverse the
and capscrews (22), securing the landing jack to the
procedure in a. above.
mounting bracket (23), and remove the jack.
4-85
