TM 5-3655-210-12
APPENDIX C
BASIC ISSUE ITEMS LIST AND ITEMS TROOP INSTALLED OR AUTHORIZED
Section I. INTRODUCTION
C-1. Scope
Code
Explanation
C
Crew/Operator (3) Recoverability code
This appendix lists items required by the
indicates whether unserviceable items should be
operator for operation of the conversion, storage and
returned for recovery or salvage. Items not coded are
charging unit.
non-recoverable.
C-2. General
Recoverability codes are:
This list is divided into the following sections:
Code
Explanation
a. Basic Issue Items List Section II. Not
R
Applied to repair parts (assemblies and
applicable.
b. Items Troop Installed or Authorized List
components), special tools and test
equipment
which
are
considered
Section III. A list of items in alphabetical sequence,
economically reparable at direct and
which at the discretion of the unit commander may
general support maintenance levels.
accompany the conversion, storage and charging unit.
These items are NOT subject to turn-in with the
S
Repair parts, special tools, test
conversion, storage and charging unit.
equipment and assemblies which are
C-3. Explanation Of Columns
economically reparable at DSU and GSU
activities and which normally are
furnished by supply on an exchange
The following provides an explanation of
basis.
columns in the tabular list of Basic Issue Items List,
Section II, and Items Troop Installed or Authorized,
b. National Stock Number.
This column
Section III.
a. Source, Maintenance, and Recoverability
indicates the National stock number assigned to the
item and will be used for requisitioning purposes.
Code(s) (SMR):
c. Description- This column indicates the
(1) Source code indicates the source for the
Federal item name and any additional description of the
listed item. Source codes are:
item required.
d. Unit of Measure (U/M). A two character
Code
Explanation
alphabetic abbreviation indicating the amount or
P
Repair parts, special tools and test
quantity of the item upon which the allowances are
equipment supplied from GSA/DSA or
based, e.g., ft, ea, pr, etc.
Army supply system and authorized for
e. Quantity Furnished with Equipment (BIIL
use at indicated maintenance levels.
Only). This column indicates the quantity of an item
Code
Explanation
furnished with the equipment.
f.
Quantity Authorized (Items Troop Installed
P2
Repair parts, special tools and test
or Authorized Only). This column indicates the quantity
equipment which are procured and
of the item authorized to be used with the equipment.
g. Illustration (BIIL ONLY). This column is
the combat or military essentially of the
divided as follows:
end item dictates that a minimum
(1) Figure number. Indicates the figure
quantity be available in the supply
system.
number of the illustration in which the item is shown.
(2) Item number.
Indicates the callout
(2) Maintenance code indicates the lowest level
number used to reference the item in the illustration.
of maintenance authorized to install the listed item.
The
maintenance
level
code
is:
C-1