TM 5-6640-212-14
Figure 4-10. Electric Heater, Parts Locations (Sheet 2 of 2)
NOTE
4-8. Cabinet Hinges. Apply a few drops of oil into hinge
If fiat side of indexing washer (3) is
pin of each of the chrome plated hinges on the cabinet
doors approximately every six months. Wipe off any
turned around 180 degrees, lock
excess oil from the chrome plated surface of the hinges.
assembly ill work in opposite
The light oil surface which re-mains on the chrome
direction when key is turned.
surface will slow down rusting of hinges.
c. Remove small Philips screw (4) located in retaining
4-9. Cabinet Locks. Cabinet locks can be replaced as
spring (5).
follows:
d. Remove retaining spring (5) from lock assembly by
a. Remove Philips screw (1, fig, 4-11) which secures
pressing or tapping out with a suitable screwdriver. It
locking tab (2) onto lock assembly (6).
might become necessary to rotate retaining spring
b. Note direction of indexing washer (3) on lock
approximately 45 degrees to gain clearance for the
assembly (6), before removing.
removal of retaining spring.
e. Remove lock assembly (6) from hole in cabinet of
drawer.
4-16
