TM 9--2520--215--34
TORQUE CONVERTER LOCKUP CLUTCH ASSEMBLY AND RELATED PARTS
REPAIR – CONTINUED
0060 00
ASSEMBLY – Continued
3. Install piston release spring (7) and clutch plate (8) into housing (9).
4. Install three locating balls (6), retaining them with oil soluble grease. Install clutch backplate (2) flat--side down,
aligning three half--round slots (14) to engage three locating balls (6).
2
6
7
8
9
14
5. Install compressor assembly and compress backplate (2) until clear of snap ring groove. Install new snap ring (3),
aligning its gap with pin hole in backplate (2). Install new spring pin (1), drive pin (1) in until pin (1) is flush with
upper surface of snap ring (3).
NOTE
FOLLOW ON MAINTENANCE:
Install lockup clutch assembly (WP 0059 00)
END OF TASK
0060 00--5/6 blank
