TM 9--2520--215--34
0062 00--6
TORQUE CONVERTER HOUSING ASSEMBLY REPAIR – CONTINUED
0062 00
ASSEMBLY – Continued
4. Install ball bearing (10) in gears (9), if removed. Support gears (9), front side down.
9
10
5. Stake edges of gear hubs over bearings (10) at four points on each gear. Place a 1/4--inch steel ball on the hub
close to bore of gear (9). Strike with hammer. Bearing (10) must rotate freely after striking.
NOTE
Assure that bent tabs on lockplates align with milled flats on lockplate mounting bosses.
6. Start two spindles (8) into front side of gears (9). Position gears (9) and spindles (8) in converter housing (5).
Align tapped holes in spindles (8) with holes in lockplates (7).
5
9
8
7
