DIRECT SUPPORT
AND
GENERAL
SUPPORT
MAINTENANCE
R E P A I R PARTS A N D SPECIAL TOOLS LIST
( I N C L U D I N G D E P O T M A I N T E N A N C E REPAIR PARTS
AND SPECIAL TOOLS)
Section I. INTRODUCTION
1. Scope.
This manual lists repair parts, special tools
and
test and support equipment required for the
per-
formance of direct support, general support,
and
depot maintenance of the AGT 9 and AGT 9A
test
stand.
2 . General.
T h i s R e p a i r P a r t s a n d S p e c i a l T o o lS List is
divided into the following sections:
a. Repair Parts List-Section II. A list of repair
p a r t s authorized at the direct support, general
support, and depot levels for the performance of
m a i n t e n a n c e . The list also includes parts which
must be removed for the replacement of the
authorized parts. Parts lists are composed of
functional groups in ascending numerical sequence,
with parts in each group listed in figure and item
number sequence.
b . F e d e r a l S t o c k N u m b e r a n d Reference
numerical sequence, of all Federal stock numbers
a p p e a r i n g in the listings, followed by a list, in
alphameric sequence, of all reference numbers are
cross referenced to each illustration figure and item
number appearance.
3. Explanation of Columns.
The following provides an explanation of
columns found in the tabular listings.
a. Source, Maintenance, and Recoverability
C o d e s (SMR).
(1) Source Code. Indicates the source for the
listed item. Source Codes are:
(2) Maintenance Code. Indicates the lowest
category of maintenance authorized to install the
r e p a i r part and/or use the special tool or test
e q u i p m e n t for each application. Capabilities of
higher maintenance categories are considered equal
or better. Maintenance codes are:
