TM 9-4910-663-34(6)Reverse the procedures of steps (1) through (5) to install the replacement transformer.u.RemovalandReplacementofVariableTransformerT3orT5(fig2-7).(1)Remove the seven 1/4-20 screws from the control panel (fig 2-5), raise panel and secure with lock bolt.Remove lower rear panel.(2)Remove the screws that attach wiring to the terminals of the transformer that is to be replaced, and detachthe wires from the transformer terminals.(3)Remove the four nuts, lockwashers, and screws that attach the transformer to the test stand, and removethe transformer.(4)Reverse the procedures of steps (1) through (3) to install the replacement transformer.3-2.BINDING POST PANEL ASSEMBLY (fig 2-6)a.Description. The binding post panel assembly contains binding posts used to make electrical connections fortesting of external components on the test stand, and three toggle switches. Repair is limited to inspection to detectdefective parts, and removal and replacement of the defective part. All repair procedures can be performed with thebinding post panel assembly installed on the test stand.b.InspectionofBindingPostPanelAssembly.(1)Disconnect main power from the test stand.(2)Remove the 10 1/4-20 screws and lockwashers that attach the right side panel of the test stand, andremove the right side panel.(3)Inspect the binding posts for indications of burning.(4)Inspect the binding posts for stripped threads.(5)Inspect the toggle switches for ease of manual operation.c.RemovalandReplacementofBindingPosts.(1)Disconnect main power from the test stand.(2)Remove the 10 1/4-20 screws and lockwashers that attach the right side panel of the test stand, andremove the right side panel.3-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business