TM 9-4910-663-34c.RemovalandReplacementofRectifierChamberBindingPosts.(1)Disconnect main power from the test stand.(2)Remove the retaining hardware from the sides and front of the I test stand control panel, raise the controlpanel, and lock the control panel in the up position with the locking bolt.(3)Open the rectifier chamber front door.(4)Remove the nut and lockwasher that secure the wire to the defective binding post.(5)Remove the two nuts, washer, and insulating washer that attach the defective binding post to the rectifierchamber, and remove the binding post.(6)Reverse the procedures of steps (1) through (5) to install the replacement binding post.3-4.BATTERY COMPARTMENT ASSEMBLY (fig 2-9)a.Description. The battery compartment assembly contains connection and mounting provisions for the batteriesused with the test stand. Repair is limited to inspection and replacement of binding posts, and replacement of adefective terminal board. Inspection and replacement of binding posts can be accomplished with the batterycompartment assembly installed in the test stand; replacement of the terminal board requires removal of the batterycompartment assembly from the test stand. Refer to paragraph 2-12 for the battery compartment assembly removalprocedure.b.InspectionofBindingPosts.(1)Disconnect main power from the test stand.(2)Open the battery compartment door. Disconnect the battery cables from the binding battery posts. Lift thebattery drawer retainer hook, pull out the battery drawer, and remove the batteries.Push the battery drawer back in.(3)Disconnect the battery cables from the binding posts, and inspect the binding posts for indications ofburning and for stripped threads.(4)Reverse the procedures of steps (1) through (3).c.RemovalandReplacementofBindingPost.(1)Disconnect main power from the test stand.Change 1 3-11
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
