MWO 9 -2330-390-35-1
b. Installer Responsibilities. The installer is responsible for following instructions in
MWO 9-2330-39-35-1, and TM 9-2330-390-14&P. The installer will report
Positioning Tube Reinforcement Kits received that are damaged or missing
component parts so the kit supplier can be properly notified. Any discrepancies
noted will be corrected before the vehicle leaves the installer's work area.
Requirements contained in this MWO shall be included in the installer's
inspection plan or quality assurance program. As a minimum, a checklist will be
maintained indicating all requirements have been satisfactorily accomplished for
each kit. These requirements shall not be construed as eliminating the installer's
responsibility fro m complete compliance with provisions of the contract and
submitting to the Government products that meet all requirements of the contract.
c. Government Verification. All QA operations, installation changes, and
inspections performed by the installer are subject to Government verification at
unannounced and varying intervals. Verification will consist of observations and
inspections to confirm that practices, methods, and procedures of the installer's
written inspection plan are being properly applied; and t hat Government product
inspection to confirm the quality of product offered for Government acceptance
does not deviate from prescribed acceptance standards specified in TM 9-2330-
390-14&P. Deviations will be brought to the attention of the installer for
d. In-process Inspection. During normal assembly operations, paragraph 10,
Modification Procedure, will be used to check the installer's work. After
installation is complete, the installer will correct any defects noted before the
Dolly is placed in service. All Dollies modified during a production shift will be
checked to ensure product quality.
14. RECORDING AND REPORTING OF THE MODIFICATION.
a. Records and Reports. The organization responsible for MWO application will
report application informatio n as follows:
Reporting will be accomplished by electronic means. MWO application
information can be input directly into the Modification Management
Information System (MMIS) over the Internet. If Internet is not available,
recording will be on a 3.5- inch disk, which will be mailed to the MMIS
administrator. Entry into the MMIS system is password protected. New
users can register on- line at http://22.214.171.124/mwo . Passwords are
normally approved and issued within 48 hours.
Submission will be comprised of nine (9) data elements listed in the table
below. Elements 1,2,4,6,7,8 & 9 are given for this MWO (as shown). The