TB 43-0213
Section Il. DRILLING AND CLEANING PROCEDURES
NOTE
Unless otherwise indicated, all holes drilled
should be sight drilled and should be 1/2
(1). Drill a 5/16 inch hole in the left and
inch (1.3 cm) in diameter.
front frame ( A and D). Holes should be drilled 6
inches from last bolt on body mount.
Drill holes at approximate locations indicated
by the black dots.
(2). Drill a 5/16 inch hole in the left and
right rear frame ( B and C ). Holes should be
drilled 8 inches from transmission crossmember
drilling instructions.
mounting bracket.
20-2