TB 43-0213
d. Drilling Front Fenders and Rocker Panels (see
B may be sight drilled. Hole C is drilled below the
center of the fender support. Hole D can be sight
drilled inside the fender well.
TA504795
Figure 5-6. Drilling Front Cargo Bed.
g. Drilling Rear of Doors (see Figure 5-7). Drill
two holes A and B in each door. Holes are sight drilled.
TA504793
Figure 5-4. Drilling Front Fenders and
Rocker Panels.
e. Drilling Taillight Opening (see Figure 5-5). Drill
one hole A in each taillight opening. Holes are sight
drilled.
TA504794
Figure 5-5. Drilling Taillight Opening.
f. Drilling Front Cargo Bed (see Figure 5-6). Drill
five holes in front of the cargo bed, Hole C is drilled
first at the center of the bed. The remaining four holes
are then spaced approximately 12 inches (30.5 cm)
TA504796
Figure 5-7. Drilling Rear of Doors.
apart.
5-3
