TB 43-0213
Section Il. DRILLING AND CLEANING PROCEDURES
Drilling Procedures.
5-2.
NOTE
Unless otherwise indicated, all holes
drilled should be sight drilled and should
be 1/2 inch (1.3 cm) in diameter.
Drill holes at approximate locations indi-
cated by the black dots.
drilling instructions.
b. Drilling Inner Hood Panel (see Figure 5-2). On
older models, drill 19 holes in the inner hood panel
support. Later models will have existing holes which are
located at points D, K, L, and R.
cowl. Holes A and B should be 5 inches (12.7 cm)
TA504791
from the inside of fenders. Hole F should be 6 inches
Figure 5-2. Drilling Inner Hood Panel.
(15.2 cm) from the inside of the fender. All other holes
are sight drilled.
TA504792
Figure 5-3. Drilling Cowl.
5-2
