TB 43-0213
D-9. Underbody Component Installation.
c. Remove rear turning fixture and install pintle.
d. Remove front turning fixture and install front lifting eyes.
e. Thoroughly clean metal surfaces of gas tank cavity and apply a coat of rustproofing compound as specified in
CAUTION
Follow the starting procedure in step h to eliminate the possibility of "hydrostatic
lock. "
h. Before starting engine, remove spark plugs and engage starter for 5-10 seconds. Install spark plugs.
D-10. Preventive Maintenance.
b. Perform preventive maintenance checks and services described in TM 9-2320-218-10 and TM 9-2320-
218-20-1-1.
Section Ill. INSTALLATION INSTRUCTIONS FOR BODY
REPLACEMENT KIT (NSN 2510-01-104-4384)
D-11. Purpose.
a. The purpose of these instructions is to provide a procedure for replacing body assemblies in the restoration of
M151A2 series vehicles.
b. This procedure is to be used when rust damage is too severe to accomplish restoration by installing the
underbody corrosion repair kit, NSN 2520-01-104-4383.
D-12. Materiel Requirements.
a. Table D-2 lists materiel that is provided with the body replacement kit, NSN 2510-01-104-4384. Using the
figure and item numbers listed below, refer to TM 9-2320-218-34P for parts identification and location
b. Serviceable parts and components will be removed from vehicle and installed on the new body. Part and
components not in the body replacement kit that are determined unserviceable will be replaced from stock.
D-14
