TB 9-2350-368-25
NOTE
Steps 6 through 13 are only for fabricating an adapter to connect the
M113A3 regulator cable to the M548A3 powerplant.
6. Cut one AWG 0 electrical lead (16) as needed.
7. Connect AWG 0 electrical lead (16) to pin E of connector (9). Label this lead circuit 6.
8. Splice two AWG 4 electrical leads (17) into the AWG 0 lead (16). Label these leads circuit 2 and circuit
2A.
9. Splice AWG 14 electrical lead (18) into the AWG 0 lead (16). Label this lead circuit 567.
10. Connect AWG 0 electrical lead (16) to pin A of connector (13), bushing (14), and nut (15).
11. Connect two AWG 4 electrical leads (17) (pins A and C) and one AWG 14 electrical lead (18) (pin E) to
connector (10), bushing (11), and nut (12).
12. Install electrical insulation tape/sleeving (19) on all leads.
13. Label this harness adapter, M548A3 only.
