TM 9-2510-247-13&P
0041 00
REMOVAL- Continued
Figure 75. Receptacle Box
INSTALLATION
1. Insert wire cable (1) into back of receptacle (9) and attach by soldering cable end to
receptacle. After wire end has cooled, pull rubber boot (11) into place over back of receptacle
(9).
2. Position receptacle (9) on junction box (10) and secure with two screws (7), flatwashers (8),
one flatwasher (5), ground cable (6), two new lockwashers (4), and nuts (3).
3. Connect the receptacle (9) to terminal cable (1) at terminal (2).
4. Connect fifth wheel towing device battery cables (WP 0050).
5. Using a multimeter, switch the 12/24 volt selector switch to 24 volts and check for 24 volt
reading at center pin of receptacle.
Follow-on Tasks:
None
END OF WORK PACKAGE
0041 00-2
