TM 9-2510-247-13&P
0071 00
REMOVAL
WARNING
CARC PAINT
CARC paint contains isocyanate (HDI) which is highly irritating to skin and
respiratory system. High concentrations of HDI can produce symptoms of
itching and reddening of skin, a burning sensation in throat and nose and
watering of the eyes. In extreme concentrations, HDI can cause cough, shortness
of breath, pain during respiration, increased sputum production, and chest
tightness. The following precautions must be taken whenever using CARC paint:
ALWAYS use air line respirators when using CARC paint unless air sampling
shows exposure to be below standards. Use chemical cartridge respirator if
air sampling is below standards.
DO NOT let skin or eyes come in contact with CARC paint. Always wear
protective equipment (gloves, ventilation mask, safety goggles, etc.).
DO NOT use CARC paint without adequate ventilation. Failure to comply
may result in death or injury to personnel.
NEVER weld or cut CARC-coated materials. Failure to comply
may result in death or injury to personnel.
DO NOT grind or sand painted equipment without high-efficiency air purifying
respirators in use. Failure to comply may result in death or injury to personnel.
BE AWARE of CARC paint exposure symptoms; symptoms can occur a few
days after initial exposure. Seek medical help immediately if symptoms are
detected. Failure to comply may result in death or injury to personnel.
1. Remove six screws (1), flatwashers (2), flatwashers (3), lockwashers (4), and nuts (5),
securing tool box (6) to fender. Discard lockwashers.
2. Remove tool box from fender.
3. Remove weather strip (7) from tool box door (8). Discard weather strip.
4. Repeat step 3 for remaining tool box door.
Figure 121. Tool Box
0071 00-2
