TM 9--2520--215--34
0003 00--1
LOCATIONS AND DESCRIPTION
0003 00
THIS WORK PACKAGE COVERS:
Location and Description of Major Components
LOCATIONS AND DESCRIPTION OF MAJOR COMPONENTS.
The XT--1410--4 and XT--1410--5A Transmissions contain the following major components. They are keyed to
Major Transmission Components. The transmission consists of:
Torque Converter Housing. The torque converter housing is cast iron and is the front member of the transmis-
sion. It has an engine flange at the front and its rear surfaces bolts to the transmission housing. It houses and
supports the lockup clutch, torque converter, input--pump drive gears, and in--put--pressure and scavenge pumps.
Its rear side supports the high--and intermediate--range clutches. Its top provides for mounting the oil filters, steer
pressure--regulating valve, and the cooler bypass, lubrication and converter pressure--regulating valve, and the
cooler bypass, lubrication, and converter pressure--regulator valve assembly.
Transmission Housing. The transmission housing is cast iron. It houses and supports the range gearing, low--
and reverse--range clutches, output bevel gears, steer gears, and drive shaft. The transmission services both oil
sump and oil reservoir. The oil sump is the area in which oil is maintained at the most efficient level for transmis-
sion operation. The reservoir is an area separated from the sump and serving, as its name implies, to hold a res-
ervoir of oil. The front of the housing provides the mounting surface for the torque converter housing. The top
surface provides for mounting main and steer control valves and inspection and access cover. The side of the
housing provide for mounting the right and left steer--clutch housing assemblies.
Steer--Clutch Housing Assemblies. Each Steer--clutch consists of:
Internal--Splined clutch plates
Pressure Plate
External--Splined clutch plates piston
Drive Gear
Piston
Hub
Clutch apply ring
Housing Assembly
NOTE
XT--141--5A transmission output reduction gear assemblies do not contain sprocket studs.
The housing mounts onto the sides of the transmission housing. The transmission housings also serve as a mounting
for the output reduction--gear assemblies:
Coupling assembly
Internal--splined brake plates
Sun gear
External--splined brake plates
Carrier assembly
Brake movable cam ring assembly
Ring gear
Saddle
Output shaft
Brake housing
Damper assembly
Output reduction housing
