TM 9--2520--215--34
0043 00--5
OUTPUT REDUCTION GEAR PLANETARY CARRIER ASSEMBLY AND
BRAKE HOUSING ASSEMBLY REPLACEMENT – CONTINUED
0043 00
INSTALLATION – Continued
3. On the XT--1410--4 transmission place bar (12) between output reduction gear shaft studs. On the XT--1410--5A
transmission, place bar (12) in keyway slot. Use torque wrench and spanner wrench to tighten nut (2) to 350 lb--ft.
Continue to tighten nut (2) until nut (2) locking pin (1) can be installed. If 450 lb--ft or more is required use
different nut (2).
4. Install pin (1) and center nut (2). Use a blunt--end drift to drive center of pin (1) down to approximately 1/16 inch.
If pin (1) remains loose, drive pin (1) 1/32 inch further. Check to ensure cork seal ring (13) is in place.
