TM 9--2520--215--34
TORQUE CONVERTER TURBINE SHAFT ASSEMBLY REPAIR – CONTINUED
0068 00
ASSEMBLY – Continued
6. Install intermediate--range sun gear (5) onto torque converter turbine shaft (2).
7. Install low--range sun gear (4), short hug end first, onto torque converter turbine shaft (2). Install new snap ring
(3).
NOTE
The three seal rings near center of torque converter turbine shaft are slightly larger in
diameter than the two toward the rear (ungrooved) end of shaft.
If repairing the XT--1410--4 transmission, perform Installation step 8. If repairing the
XT--1410--5A transmission, perform Installation steps 8 and 9.
8. Install six new hook--type seal rings (1) into grooves on torque converter turbine shaft assembly (2).
9. Press pin (11) into torque converter turbine shaft assembly (2) to a depth of 0.26 inches.
NOTE
FOLLOW--ON MAINTENANCE:
Install torque converter turbine shaft assem-
bly (WP 0067 00)
END OF TASK
0068 00--7/8 blank
