TM 9--2520--215--34
0068 00--5
TORQUE CONVERTER TURBINE SHAFT ASSEMBLY REPAIR – CONTINUED
0068 00
ASSEMBLY
NOTE
Install new snap ring if removed for maintenance purposes.
1. Support roller (10) inner race, numbered side down, in press. Insert torque converter turbine shaft (2) rear
(ungloved) end down, into bearing race (10). Press torque converter turbine shaft (2) into roller bearing race (10)
until seated against snap ring.
2
10
2. Remove torque converter turbine shaft (2) from press. Install high--range clutch hub support (9) with external
snap ring groove toward roller bearing race (10).
