TM 9-4910-663-34
Section V. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS AND AUXILIARIES
2-11.
GENERAL. This section provides instructions for removal and installation of test stand assemblies authorized at
the direct support maintenance level. See figures 2-4 thru 2-11 for the locations of the major assemblies of the stand.
2-12.
REMOVAL AND INSTALLATION OF BATTERY COMPARTMENT ASSEMBLY.
a.
Disconnect main power from the test stand.
b.
Remove the panel retaining hardware from the side panel of the I test stand, and remove the side panel.
c.
Open the battery compartment door and the high voltage compartment door (fig 2-9).
d.
Detach the door interlock switch (S4, fig 2-8) and bracket from the high voltage compartment by removing two
screws, lockwashers, I and nuts.
e.
Remove the nuts, washers, and wiring from the rear of the battery terminal posts.
f.
Lift the battery draw retaining hook, and pull the battery drawer out against the stop.
g.
Remove all battery cables used to connect batteries to the battery compartment binding posts.
h.
Remove eight wing nuts and washers, and remove the battery holddown brackets.
i.
Remove all batteries.
j.
Unscrew the eight tie rods from the battery drawer.
k.
Remove the six screws, lockwashers, and washers that secure the track U-brackets and the battery enclosure to
the test stand.
1.
Remove the U-brackets and the battery enclosure from the test stand.
m.
Reverse the procedures of steps a through 1 to install the battery compartment assembly in the stand.
Change 1 2-61
