MWO 9-2330-392-20-1
MODIFICATION PROCEDURES.
1. Remove cotter pin (1), flat washer (2) and master pin (3) from housing (4).
Discard cotter pin and master pin. (figure 1)
1
3
5
2
4
2. Pull inner slide (5) from housing (4); master rollers are on either side of damper
inside the inner slide and will be discarded in step 4. (figure 1)
3. Remove damper cotter pin (6), washer (7) if installed and damper pin (8) from
front of inner slide (5). Discard cotter pin and washer. (figure 2)
14
11
6
13
12
7
8
1010
U
9
5
