MWO 9-2330-392-20-1
34
16. Install supplied tie-wrap (34) on emergency brake lever/cable assembly (figure
7). Make sure
tie wrap goes through the eye of
the "S" hook and
around the
lever. This ensures the cable cannot be damaged by contact between the sheet
metal master cylinder cover and the cast housing when the trailer is in service.
37
9
35
8
37
36
17. Install the damper (9) in inner slide P/N 12479774 (35). The small damper-eye
goes in first, toward lunette ring. Secure the damper re-using the damper pin (8)
removed in Step 3; ensure the damper pin passes through the damper eye. Install
a new cotter pin P/N MS24665-421 (36) through the damper pin. (figure 8)
18. Install new supplied rollers P/N 12479776 (37) inside the inner slide (35), on
either side of the rear damper eye. (figure 8) The rollers must have the
chamfered sides facing the walls of the inner slide. Align roller holes with rear
damper eye so that master pin can pass through the inner slide slot, the rollers and
the rear damper eye.
9