TB 43-0213
Figure 9-5. Drilling Top Side Rail and Cutting Stake Pockets.
9-3.
Cleaning Procedures.
WARNING
When cleaning, water may be discharged in
excess of 1200 psi (8274 kPa) from high
pressure water equipment. Serious injury
could result. Eye protection must be worn
to prevent injury.
CAUTION
Steam cleaning will not be used.
a. Wash the interior of structures through drilled
access holes to remove mud, dirt, and rust. Use of a
high pressure washer will facilitate this operation.
Observe the water flushed through the rails to
determine if it is clean.
b. Allow at least four hours for vehicle drying.
Figure 9-6. Underbody.
Additional drying time may be required if unfavorable
9-3
