TB 43-0213
(2) Use 90 degree short tool to spray overall
(2) Insert short rigid tool as far as it will go into
areas missed by flexible tool.
each of the supports and stiffener B. It may require two
passes to ensure complete coverage.
(3) Spray inner door panels, after rolling
(3) Use long rigid tool to spray the entire side of
windows up to a fully closed position. Use a short rigid
the rear fenders C.
tool to completely cover the inside of the inner door
panel B. Caution should be taken not to spray
(4) (M983 Only). Use the short rigid tool to
compound on window mechanism.
spray the entire underside of the rear fenders D,
(5) Insert flexible tool as far as it will go into the
(4) Use the short rigid tool to spray the inner
engine cover support tubes E, then slowly withdraw the
side of the door access cover.
tool while spraying.
f. Rustproofing Roof Center Support and Complete
Doorjamb Opening (Typical) (see Figure 19-10).
(1) Insert flexible tool into access hole A in the
front doorjamb as far as it will go, then spray while
slowly withdrawing tool.
(2) Insert flexible tool into access hole B in the
top doorjamb as far as it will go, then spray while slowly
withdrawing tool.
(3) Insert flexible tool into access holes C in the
roof center support as far as it will go, then spray while
slowly withdrawing tool.
g. Rustproofing Engine Cover Support Tubes, Cab
Angle Braces and Fenders, Supports and Stiffeners (see
TA504938
(1) Use short rigid tool at cab angle braces to
Figure 19-10. Rustproofing Roof Center
spray the entire underside of the cab floor. Insert the 90
Support and Complete Doorjamb
degree short tool in each hole A and spray in each
Opening (Typical),
direction.
TA504939
Figure 19-11. Rustproofing Engine Cover Support Tubes, Cab Angle Braces and Fenders,
Supports and Stiffeners.
19-5
