TB 43-0213
C.
Drilling Tailgate (All Models) (see Figure 20-
3). Drill two 1/2 Holes (A and B) on left side of
tailgate.
Figure 20-3. Drilling Tailgate.
d. Drilling Weapon Station Tray Assembly
(M996, M1036,M1046, M1025, M1026, M1043
and M1044 Models see Figure 20-4)
(1) Drill two holes D and E in Channel C.
Hole D should be 12 inches from the end of the
opening in Channel C. Hole E should 12 inches
from Hole D.
Figure 20-4. Drilling Weapon Station Tray Assembly.
20-3. Cleaning Procedures<
WARNING
facilitate this operation. Observe the water
flushed through the rails to determine when it is
When cleaning, water may be discharged in
clean.
excess of 1200 psi (8274 kPa) from high
pressure water equipment. Eye protection
b. Allow at least four hours for vehicle drying.
must be worn to prevent injury.
A d d i t i o n a l drying time may be required if
unfavorable
weather
conditions
exist.
CAUTION
Compressed air may be used to speed up the
drying process.
Steam cleaning will not be used.
c. Prime and paint those areas showing bare
a. Wash the interior of framerail structures
metal. AIlow painted areas time to dry before
through drilled access holes, to remove mud, dirt,
rustproofing.
and rust. Use of a high pressure washer will
20-3
