TB 43-0213
18-5. Rustproofing Inspection.
a. Check the vehicle to ensure that all areas
requiring rustproofing compound have been properly
and completely coated.
(1) Check seams, welds, corners, and boxed
areas to ensure that they are adequately coated.
(2) Check wet film thickness with a wet film
thickness gage (see Figure 18- 10). A wet film thickness
of 10 roils is required. In areas where a wet film
thickness of 10 roils cannot be obtained or where
thickness cannot be measured, inspect for complete-
ness of coverage.
TA504927
Figure 18-8. Rustproofing Doors.
TA504789
Figure 18-10. Film Thickness Gage.
(3) Check all drain holes to ensure that they are
open.
(4) Check all inspection holes and drilled
access holes to ensure that compound coverage is
adequate. Use of a high intensity inspection light will
enhance this process.
(5) Check vehicle to ensure that no compound
has been applied to prohibited areas (see CAUTION,
NOTE
Plugging of access holes may be delayed
until after vehicle inspection, if inspection
occurs immediately after rustproofing. If in-
spection is delayed too long, rustproofing
compound may drip from access holes.
b. Plug access holes.
18-6. Component Installation.
TA504928
Install all components that were removed in
Figure 18-9. Rustproofing Underbody.
18-5/ (18-6 Blank)
