TB 43-0213
TA504980
Figure E-1.Straight-Edge Floor Scraper.
E-4. Assembly Instructions (See Figure E-1.
a. Support Arms to Handle, Position one end of both support arms over hole B in handle and install screw, two
flatwashers, and nut.
NOTE
Center hole C on blade should be positioned so that scraping edge faces outward.
b. Blade to Handle. Position center blade hole C over handle hole A and install screw, two flatwashers, and nut.
c. Support Arms to Blade. Position free ends of support arms on each side of blade. Install two screws, four
flatwashers, and two nuts.
Section II. LOOPED SCRAPER
WARNING
Wear protective gloves to avoid injury during fabrication of looped scraper. Material
has sharp edges which may cause serious injury to personnel.
NOTE
All dimensions given in Section II are in standard units.
E-5.
General.
There are many curved areas underneath a tactical vehicle where a straight-edge scraper or putty knife cannot
reach. The looped scraper will work well on both convex and concave curves.
E-2
