TB 9-2350-368-25
SECTION VII. TEST EQUIPMENT FABRICATION
TEST EQUIPMENT. The fabricated test tools consist of transmission stall test tool and brake stall
2-7.
test tool. These tools are needed because without the carrier, there is no way to apply the brakes to prevent
the transmission from moving.
a. Transmission Stall Test Tool
Bill Of Materials
Item
Nomenclature
Part Number
NSN
Qty
3/8" Steel Plate
1
6 by 14-1/2 inches (15.2 by 36.8 cm)
1
2
7-5/8 by 14-1/2 inches (19.4 by 36.8 cm)
1
1/2" Steel Plate
3
3 by 5-27/32 inches (7.62 by 14.8 cm)
1
2 1/4" by 2 1/4" Block Steel
4
14-1/4 inches (36.8 cm)
1
Hardware
5
Cap Screw (7C)
B1821BH050F200N
4
6
Washer (7C)
11678182
5310-00-011-5730
4
7
Cap Screw (6C)
B1821BH037F100N
4
8
Washer (6C)
10910174-33
4
9
Cap Screw
B1821BH044C550N
3
10
Washer
MS27183-60
3
11
Nut
MS51967-11
3
1. Cut one 6- by 14-1/2- by 3/8-inch steel plate (1). Scribe a line 8-1/4 inches from the end of plate (1). Scribe
another line 2-1/4 inches from the first scribe line. See Figure 2-27.
2. Scribe a line 2-1/4 inches from the side of 3/8-inch steel plate (1). See Figure 2-27.
3. Cut 2-1/4-inch square where scribed lines meet on 3/8-inch steel plate (1).
4. Drill a 17/32-inch hole next to the square one inch from the side and six inches from the end of 3/8 inch
steel plate (1).
5. Drill two 17/32 inch holes one inch from the end and one inch from the side of 3/8-inch steel plate (1). See
6. Cut 7-5/8- by 14-1/2- by 3/8-inch steel plate (4). Cut the corners of as shown in Figure 2-27.
7. Weld 3/8-inch steel plates (1) and (4) per Figure 2-27.
8. Make a 3- by 5-27/32-inch plate (2). Drill four holes and round off corners to match the transmission
yoke. See Figure 2-27.
9. Cut 2-1/4 inch by 2-1/4 inch block steel (3) 14-1/4 inch long. See Figure 2-27.
10. Weld 1/2-inch steel plate (2) to end of 2-1/4 inch block steel (3) at the same height as the transmission
yoke.
11. Weld 2-1/4 inch block steel (3) after inserting into square in 3/8-inch steel plate (1).
