TM 9-2510-247-13&P
0077 00
INSTALLATION
1.
Position winch assembly (6) in bracket (2).
CAUTION
To prevent contamination of hydraulic system, DO NOT remove caps
and/or plugs from hydraulic lines and ports until ready to connect.
2.
Install four screws (3) on winch bracket (2) and winch assembly (4).
3.
Install two elbows (5) on winch motor (6).
4.
Connect both winch hydraulic hoses.
5.
Charge hydraulics (WP 0056 00-5).
6.
BOOM RETRACT to bring boom to upright position.
7.
Install eight screws (1) on winch bracket (2).
Figure 128. Winch Assembly
CABLE ASSEMBLY REMOVAL
WARNING
If winch cable has to be cut to remove winch assembly, wrap cut end
of cable in tape and secure loose end of cable to prevent it from
swinging free during winch assembly removal. Failure to follow this
warning could result in injury or death to personnel.
CAUTION
To prevent contamination of hydraulic system, cap and/or plug hydraulic
lines and ports after disconnecting lines.
0077 00-3
