TM 9--2520--215--34
0027 00--5
STEER CONTROL VALVE ASSEMBLY REPAIR – CONTINUED
0027 00
ASSEMBLY
1. Install two new inner retaining rings (18) in steer control valve body (2), if removed.
NOTE
The XT--1410--5A transmission contains only one spring on each steer control valve
assembly and they are not interchangeable with those on the XT--1410--4 transmission.
2. On the XT--1410--4, install inner and outer steer control compression springs (12 and 13), detent plunger (11), and
jam nut (10) on each steer control valve (9). Temporarily adjust jam nut (10), but do not lock it. Install two steer
control valve (9) in steer control valve body (2).
3. On the XT--1410--5A, apply sealing compound to threaded end of each steer control valve (9) and install steer
control compression spring (12), detent plunger (11), jam nut (10) and new self--locking nut (14). Do not tighten
jam nut (10) or self--locking nut (14).
4. Install two steer control valve (9) in steer control valve body (2).
5. Install new preformed packing (6) in steer control valve body (2). Seat preformed packing (6) in groove in steer
level shaft (5) bore.
6. Install steer control level shaft (5) making certain the two pins in the shaft engage the slots in the two detent
plungers (11), on the valve assemblies (9).
7. Install steer detent plug assembly (1). Torque plug to 40--50 lb--ft.
9
9
1
10
18
18
5
2
14
10
11
12
13
13
12
11
14
6
