TM 9--2520--215--34
0027 00--6
STEER CONTROL VALVE ASSEMBLY REPAIR – CONTINUED
0027 00
ASSEMBLY – Continued
8. On the XT--1410--4 transmission, with the valve in the neutral position and the detent ball seated in the central
groove of the steer lever shaft, adjust the steer valve detent plunger nuts to obtain a 0.025 to 0.035--inch
clearance at the point shown. Lock the nuts to the valve stems by peening the inside diameters of the nuts
against the flattened sides of the valve stems.
9. On the XT--1410--5A transmission, with the valve in the neutral position and the detent ball seated in the central
groove of the steer lever shaft, adjust the jam nuts (10) to obtain a 0.025 to 0.035--inch clearance at the points
shown.
10. Remove two steer control valves (9) from steer control valve body (2) and, with a dowel pin through the 0.25 hole,
while holding the jam nuts (10), torque self--locking nuts (14) to 100 to 110 lb--in. Reinstall steer control valves (9)
in steer control valve body (2) and recheck gap in accordance with step 9 above.
11. Install steer position indicator (4) and new external retaining ring (3) on steer control lever shift (5).
12. Install two new annular gaskets (8) and two plugs (7). Torque plugs to 90 to 100 ft--lb.
13. Install two new preformed packings (17) on two plugs (16) and install in steer control valve body (2).
14. Secure plugs (16) in steer control valve body (2) with two new outer retaining rings (15).
.025 TO
.035 INCH
14
9
7
3
4
2
5
---4 MODEL
ONLY
---4 MODEL
ONLY
8
9
8
10
14
10
17
17
15
16
15
16
NOTE
FOLLOW--ON MAINTENANCE:
Install steer control valve assembly
(WP 0026 00)
END OF TASK
