TM 9--2520--215--34
0066 00--4
INTERMEDIATE--RANGE PLANETARY CARRIER ASSEMBLY REPAIR –
CONTINUED
0066 00
ASSEMBLY – Continued
4. Install assembled pinion (4) into intermediate--range carrier assembly (1). Align parts carefully with spindle bore
in carrier.
5. Position spindle (2), solid end up, so that lock ball pocket (7) is aligned directly over lock ball pocket in
intermediate range carrier assembly (1). Press spindle (2) into intermediate--range carrier assembly (1) until its
lock ball pocket is near intermediate range carrier assembly lock ball pocket.
6. Insert lock ball (3) into spindle pocket (7). Press spindle (2) into intermediate--range carrier assembly (1) until
upper end is flush with carrier.
7. Repeat steps 2 through 6 to assemble three remaining pinions, 66 rollers and 12 thrust washers.
8. Remove intermediate range carrier assembly (1) from press and stake carrier around solid end of spindles (2).
Center punch ten or 12 points approximately 1/16 inch from spindles (2), or use a blunt tool to peen about 30
percent of the circumference of carrier bore against end of spindles (2).
NOTE
FOLLOW ON MAINTENANCE:
Install intermediate range carrier assembly
(WP 0065 00)
END OF TASK
