TM 9--2520--215--34
0075 00--4
OUTPUT PRESSURE AND BRAKE COOLANT PUMP AND OUTPUT
DRIVESHAFT REPLACEMENT – CONTINUED
0075 00
INSTALLATION
1. Position transmission housing (13) on rear side. Install output drive shaft assembly (10) leaving suspended on
rope sling. Apply a coat of non--hardening gasket cement to output pressure and brake coolant pump mounting
surface (14).
2. Apply a coat of non--hardening gasket cement to base of output pressure and brake coolant pump assembly (11).
Install new gasket (15) onto output pressure and brake coolant pump assembly (11) base. Work through
transmission housing (13) inspection port to install output pressure and brake coolant pump assembly (11). Push
output pressure and brake coolant pump assembly (11) under output drive shaft assembly (10) and lift into
position on mounting pad.
