TM 9--2520--215--34
0077 00--1
OUTPUT DRIVESHAFT AND RELATED PARTS REPAIR
0077 00
THIS WORK PACKAGE COVERS:
Disassembly, Cleaning, Inspection, Fit and Wear Limits, Assembly
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0088 00)
Arbor press (item 26, WP 0088 00)
Retaining ring pliers (item 27, WP 0088 00)
Torque wrench (item 34, WP 0088 00)
Torque multiplier (item 35, WP 0088 00)
Materials/Parts
Retaining ring (3) (item 65, WP 0087 00)
Retaining ring (2) (item 66, WP 0087 00)
Materials/Parts – Continued
Retaining ring (item 64, WP 0087 00)
White lead (item 19, WP 0085 00)
Lumber (item 24, WP 0085 00)
Equipment Conditions
Output drive shaft removed (WP 0075 00)
DISASSEMBLY
1. Remove four spanner nut lock rings (1) from four spanner nuts (2) on drive shaft (3). Discard lock rings.
2. Loosen (approximately four turns) spanner nut (2) which is against output pump drive gear (4).
3. Drive output bevel driven gear (5) toward center of drive shaft (3) and remove snap ring (6) retaining gear.
Discard snap ring.
