TM 9--2520--215--34 0077 00--6 OUTPUT DRIVE SHAFT AND RELATED PARTS REPAIR – CONTINUED 0077 00 FIT AND WEAR LIMITS – CONTINUED Check the following parts to the dimensions listed.  Replace if not within the specified dimensions. PART NAME CHECK POINTS ACCEPTABLE LIMITS Steer tie shaft idler gear Steer bevel drive gear Steer bevel drive gear thrust washer Steer cross shaft Roller bearing Steer tie shaft Roller bearing Gear bearing surfaces OD Bearing surface OD of gear hub Thickness of washer Bearing surface OD Bearing fit on shaft Bearing surface OD Bearing surface OD Bearing fit on shaft Bearing surface OD Bearing fit on shaft Bearing ID Bearing fit on shaft Bearing OD Fit of bearing races in housing bores Shaft bearing surface OD Bearing fit on shaft Shaft bearing surface OD Bearing fit on shaft Bearing outer race ID Fit of inner race in outer race Bearing outer race OD Fit of bearing in bores Bearing ID Bearing fit on shaft Bearing inner race OD Inner race fit in outer race 1.3783 to 1.3788 in. Wear limit: 1.3781 in. 2.2488 to 2.2494 in. Wear limit:2.2483 in. 0.1260 to 0.1300 in. Wear limit: 0.1210 in. 1.5740 to 1.5746 in. Wear limit: 1.5737 in. 0.0003T to 0.0008L 1.9660 to 1.9675 in. Wear limit: 1.9665 in. 2.1643 to 2.1649 in 0.0001T to 0.0011L 1.9950 to 1.9955 in. Wear limit: .1.9935 in. 0.0015L to 0.0030L 1.5743 to 1.5748 in. 0.0003T to 0.0008L 3.5427 to 3.5433 in. 0.0005T to 0.0011L 1.9681 to 1.9687 in. Wear limit: 1.9678 in. 0.0007T to 0.0004L 2.1650 to 2.1655 in. Wear limit: 2.1647 in. 0.007T to 0.0004L 3.4653 to 3.4659 in. 0.0022L to 0.0032L 3.9364 to 39370 in. 0.0005T to 0.0011L 2.1648 to 2.1654 in. 0.0007T to 0.0004L 3.4627 to 3.4631 in. 0.0022 L to 0.0032L