TM 9--2520--215--340077 00--10OUTPUT DRIVE SHAFT AND RELATED PARTS REPAIR – CONTINUED0077 00ASSEMBLY -- CONTINUEDWARNINGUse tongs or gloves to prevent injury when handling heated parts.NOTEOn the XT--1410--5A transmission, heat bevel gear to 300 degrees Fahrenheit prior topressing bevel gear onto shaft.4. Install bevel driven gear (5), tooth side first, onto long--splined end of shaft (3). Press shaft (3) into gear (5) untilsnapring can be installed. Install new snapring (6).5. On the XT--1410--4 transmission, tighten spanner nut (2) against oil pump gear (4) until output bevel driven gear(5) is tight against snapring (6) and hole in spanner nut (2) align with slot in shaft.6. On the XT--1410--5A transmission, tighten spanner nut (2) against oil pump drive gear (4). Secure spanner nut(2) with spanner wrench to inside of gear housing. Attach spline wrench to oil pump drive gear end of shaft (3)and attach torque multiplier to spline wrench. Torque to 500 to 800 lb--ft. Output bevel drive gear (5) must betight against snapring (6) and hole in spanner nut (2) align with slot in shaft.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
