TM 9--2520--215--34
0021 00--2
ADJUSTING DRIVE SHAFT PRELOAD – CONTINUED
0021 00
ADJUSTING DRIVE SHAFT PRELOAD – Continued
3. Check endplay of drive shaft (3). Use dial indicator (4) to check endplay.
3
4
NOTE
Tap inner race of right drive shaft bearing down against spanner nut while backing off nut.
4. After all endplay is eliminated, back off spanner nut (2) (tightened in step 2 above) until 0.002-- to 0.005--inch
endplay can be measured.
2
